A furnace is necessary for warmth in the harsh winter months. To run successfully and efficiently, furnaces, on the other hand, need periodic expert tune-ups and domestic maintenance.
Even with great care, furniture will break down and sustain defects, causing it to cease performing correctly. Try these furnace troubleshooting solutions before hiring a professional from our HVAC repair Livermore CA, if your furnace won’t turn on.
Take a Look at the Furnace Filter.
Air filters are the primary thing you should notice. Furnace filters get clogged over time. Filters will quickly get clogged with dirt and dust, restricting circulation, decreasing indoor air quality, and, in some cases, preventing the heater from turning on. In addition, it will pose a fire hazard and cause premature breakdowns due to excessive dust and grime.
Investigate the Furnace’s Flame.
Your furnace’s flame should be a brilliant blue with a little yellowish tip. The blue flame signifies that your gas furnace safely and effectively burns the fuel.
If the flame is red, yellow, purple, green, or any color other than blue, call a professional right away. Never attempt to adjust the color of the flame in your furnace on your own instead, call our heater services Livermore CA.
Check the Pilot Light.
You’ll have to relight the furnace if the flame is out when you check it. While you will relight the pilot independently, proceed with care and refer to your owner’s manual for instructions.
Before relighting the pilot, remember to switch off the gas for around 10-15 minutes. Then, if you still smell gas, don’t go any farther! If you suspect a leak, get out of the house right away and call the gas company and the fire department at once.
Make Sure the Front Panel is Secured Correctly.
Follow the manufacturer’s instructions for properly securing the access panel. Many furnaces will not operate if the board is not completely put in.
All Vents and Registers Must Be Open and Free of Obstructions.
Make sure there aren’t any obstacles in the way of airflows, such as rugs, furniture, or other things. Blocked vents and registers are not only inconvenient, but they will also lead to duct leaks due to excessive air pressure, as well as breakdowns and HVAC repair Livermore CA.
It’s not a good idea to close vents and registers in rooms that aren’t in use. You won’t save any money, and you’ll end up causing more problems for your heating system.